|
IDE Internal (old) specification users reports and reviews |
| Date | User opinion | Comment | Content Revision |
Approved by moderator? |
|---|---|---|---|---|
| CORRECT | Work Correctly!!!!!! | APPROVED | ||
| CORRECT | Good Layout only one I could find. | APPROVED | ||
| CORRECT | yep works | APPROVED | ||
| 2009-08-21 15:33:30 | CORRECT | rev. 2 | APPROVED | |
| 2010-03-21 00:32:06 | ERROR FIXED | I believe the male connector pinout is wrong -- if the female connector (which I believe is right) were connected to the male controller as listed, pin 1 from the controller (/RESET) would connect to pin 40 on the drive (GND) which isn't right. The "ATA / IDE" interface pinout has the same problem. The actual pin descriptions seem to be correct, but I think the male connector should show the top-left pin as 39, bottom-left as 40, top-right as 1, and bottom-right as 2. Staring at an IDE drive for a few minutes seems to confirm what I'm thinking. | rev. 2 | APPROVED |
| Date | Author | Content Revision |
Comment |
|---|---|---|---|
| 2011-05-02 22:19:08 | andy | rev. 3 |
Pinouts.ru > Pinout of IDE Internal (old) and layout of 40 pin IDC male connector and 40 pin IDC female connector |
should be correct |